Lambda sensor

[Paros]

I was hoping to get a Quick answer from here
I am about to change to lambda sensor on my Atom 2 300 UK.
I bought a Honda original sensor, but Ariel has change the connector, so I have to use the old connector on the new sensor.
There are 4 wire, 1 green, 1 White and 2 black. I have mixex up which one is going where (the black ones) on the Ariel sensor after cutting them.

On the Ariel sensor - if looking at the sensor and the connector, are the black wires straight or crossed from the sensor to the connector?

[John Scherrer]

Not sure if this helps - Picture from 3-245

The wires look like 2 blacks, 1 blue, 1 white

[John Scherrer]

2.

[John Scherrer]

3.

[Paros]

On my Atom2 300, the order is: green, black, white, black on the sensor and connector.
I need to know if they have switched/crossed the black cables.

[smokin]

Hi Paros,

do you have the part number for the Honda sensor? Is it 36531-PRB-A01? hope so.

This should help, particularly the wiring diagram  http://www.hondata.com/techk20-ctr-o2wiring.html

also see the o2 sensor detail in this http://www.karcepts.com/index_files/instructions/WH01EK%20Installation%20Instructions.pdf