Cams

[FAST BUCK]

Would anyone know what I should be paying for a upgraded camshaft kit for my K20?
I presume there is a few out there, I'm not being told much about it , just that it's specially designed for a turbocharged K20
i've been told it'll add over 20hp which will enable me to run lower boost and save the engine.

[McFred]

I'm in the US and so those are the products I am most familiar with.
Brian Crower actually has forced induction cams that can be located here:
http://crower.com/cat/import/honda/cams/k20a2.shtml

Ron at IPS has done a LOT of R&D for naturally aspirated K-series platforms.
He shares a lot of information at www.K20A.org and sells his products here:
http://intrinsicperformance.com/products.html
I heard that he was developing forced induction cams, but I have not followed up on it recently.

And Skunk2 has K-series cams but I don't know much about applications and their site does not
have too much information.  It could not hurt to contact them.
http://www.skunk2.com/

[FAST BUCK]

Thanks Mc Fred,
I'm being charged £1200 for Cams, Titanium retainers and valve springs ,does that sound right to you?
I'm only going for the upgraded cams so i can turn the boost down to a safe setting but still keep the power I want.

[Driver]

if you look at what IPS charges ($1200) and the additional cost of the Springs & Ti retainers ($400) then the price you are being charged doesn't look so bad.

[FAST BUCK]

good, they were put in today!      i get my rolling chassis on Monday!  yipee