Parking brake adjustment....

[maverick1]

I adjusted my parking brake yesterday, but was a little confused by the manual.
The manual says to "take a 1/4 in allen wrench and turn the internal hex bolt in the center of the large end of the parking brake application lever clockwise until the wheel cannot be turned by hand then turn the allen bold counter-clockwise about 1/16 of a turn. At this point the parking brake is initialized and the cables can be adjusted"....whatever this means.
I just ended up adjusting the two adjustment screws at the back of the car near the brake assembly as shown in the pics. Is what I did ok?
cheers

[maverick1]

One more.

[silver]

if it works then it's ok

[bolus]

I refuse to answer until you wash your car.  yuk! 

[maverick1]

[quote="bolus"]
I refuse to answer until you wash your car.  yuk!   ;D
[/quote]
I thought you might chime in on this one Bolus. The flash makes it look dirtier than it is.
cheers

[silver]

[quote="maverick1"]
[quote="bolus"]
I refuse to answer until you wash your car.  yuk!   ;D
[/quote]
I thought you might chime in on this one Bolus. The flash makes it look dirtier than it is.
cheers
[/quote]

hahaha excuses excuses

[bolus]

what kind of excuse is that?  You mean it looks dirty in the light?  If it is pitch black it is completely clean.   bah...

[J_Edwards]

Just take some of this...
http://www.glisteningperfectionstore.com/servlet/the-151/P21S-Total-Auto-Wash/Detail

Add some work with a brush and a hose and you are good to go...

Being a detailer aside... there is a difference between caring if it is dirty, and caring if it is clean.