2011 K20z3
I have Dash2 (Race Technology) - I don't have a fuel indicator in the Dash2. I don't have a fuel sender in the tank.
Can someone help what sending unit i need to buy? I have a 10 gallons.
Also I appreciate if you can tell me what pull up resistor I need & the equation to the Dash2 race technology.
Thank you
Dash2 Race technology gauge question
Re: Dash2 Race technology gauge question
I have the Dash 2 set up to read fuel pressure / oil pressure / oil temp as well as standard stuff.
I found it far easier to go on Race Technology's website and buy the sensors directly from them. As far as i know they also supply any pull up resistors required.
That way when you configure the dash using the software the standard sensors are already configured together with the equations needed to work.
Cheers
Stuart
I found it far easier to go on Race Technology's website and buy the sensors directly from them. As far as i know they also supply any pull up resistors required.
That way when you configure the dash using the software the standard sensors are already configured together with the equations needed to work.
Cheers
Stuart
Re: Dash2 Race technology gauge question
Thanks Stuart --- I will buy the sending unit to race technology.
Re: Dash2 Race technology gauge question
I dont find a fuel-level sensor on the race technologys website.
I whant to upgrade from the rove untit that is not very acurate. Shows only 10ltr difference from emty to full :-)
I whant to upgrade from the rove untit that is not very acurate. Shows only 10ltr difference from emty to full :-)
Who is online
Users browsing this forum: No registered users and 1 guest